An animated 3D model of the ifurno mobile service workstation. It starts as a sealed carton, unpacks onto the floor, builds up step by step into a lit, fully kitted repair bench, and ends in an explorer where you can turn it, open an exploded view, switch between the 4 ft and 5 ft widths and change the edge trim.

Mobile service workstation

A repair bench. One flat box.

A steel bench for phone and electronics repair by ifurno Lifestyle, with its own light, pegboard, eight shelves and a keyboard tray. In 4 ft and 5 ft widths.

Arrives flat

Frames, boards, two perforated back panels and a bag of fixings come packed flat in one carton, under a foam sheet and edge guards.

Laid out on the floor

Unpack the parts and lay them out by size. The two side frames go down exactly where the bench will stand.

ASide frame2×
BDesk frame1×
CFootrest1×
DPegboard panel2×
ELight canopy1×
FDesk top1×
GShelf8×
HKeyboard tray1×
IFixings bag1×

Raise the side frames

Tilt each side frame upright, bolt the desk frame between them with the hex key from the fixings bag, then fix the footrest across the feet.

Pegboard and canopy

Bolt the two pegboard panels across the back, one above the other, then lower the canopy with its LED panel between the frames and fix it at the corners.

Desk, shelves and tray

Lay the desk top on its frame, bolt the eight shelves to the side frames, four a side, then fit the keyboard tray under the desk.

Ready for repairs

Microscope, TV, power supplies, PC and UPS each have a place, and the overhead panel lights the whole bench.

Frame: 50 mm steel square tube, bolted
Back: Two perforated steel panels
Light: LED panel in the canopy
Trim: Red, blue or black edge
Size: About 1300 × 610 × 1950 mm